![]() ![]() A trunk must be setup in order to make outbound calls.This will allow you to make calls to destinations based on rules. Next we will setup Outbound Routes here you can setup your dialing patterns.To setup your phone system to make and receive calls, setup Inbound Routes you can create anything for the Description, then use one of your numbers for the DID Number then Set Destination this will be the destination where incoming calls will be routed then select Submit.After you have entered the credentials from the email, you can check the registered channels by going to FreePBX System Status then look under Total active channels. ![]() ![]() In order to have a softphone registered you will need to setup Trunks, and enter your PEER Details from the email of your registration email.On the left hand side you will see a list of options.The username for a first time login is maint and the password is what you have entered earlier in the command line of setup. Next click the FreePBX Administration this will take you into the GUI of the PBX.To begin you will need to enable PBX in a Flash for Admin this is done by clicking on the Users.Once the IP Address has been typed in you will be able to see PBX in a Flash with the Icons: Voicemail & Recordings, Flash Operator Panel, and MeetMe Conference for users, and FreePBX ® Administration,Linux Webmin, and Menu Configuration for the Admin user. After Installation you will need to obtain your IP Address. Start this tutorial after you have completed PBX in a Flash Setup.
0 Comments
Leave a Reply. |